Home << Product Main << Night Vision Cam Main

 

 Installation Guide of Day Night Vision Vandalproof Dome Camera

 

 

 Click pictures to view the enlarged version...


click to enlarge...click to enlarge...

1. Unscrew all Allen screws with the enclosed Allen wrench to open the dome cover.


click to enlarge...click to enlarge...

2. Locate the camera and affix the camera mounting bracket using four long screws included as it shown on the left picture. Lay out the camera cable through either side hole or bottom hole if you plan to have wiring hidden going through the ceiling or wall.


click to enlarge...

3. Attached the camera body to the affixed the camera mounting bracket using four small screw enclosed firmly and connect the camera cable to the extension cable connected to the outcome device as as Yellow to Video, White to Audio (if available), and Red to DC-12V power source.


click to enlarge...

4Connect the other end of the extension cable as Yellow to Video-in & White to Audio-in (if available) on the back of the recording device or outcome display monitor (if connecting directly to the monitor), then Red to the included 12V power transformer or your own 12V power source.


5. Connect the other end of the cable to the outcome display monitor either directly from the camera or recording device (if the camera is connected via) as the connection procedure explained on 5 and power up all equipments that connected the system.


click to enlarge...click to enlarge...

6. Go to the camera location and unscrew both sides of the lens holding base as it shown on the left picture to adjust the panning angle.


click to enlarge...click to enlarge...

7. Unscrew both sides of the camera base as it shown on the left picture and adjust the tilting angle.


click to enlarge...

8. Unscrew the knob labeled &<--->N to adjust zoom length and unscrew the knob labeled T<--->W to focus, then screw knobs back to fix the lens firmly and also screw back the camera housing. Next step, adjust viewing angle of the camera looking at the connected monitor and tighten back the joint knob turning it clockwise firmly when the camera-viewing angle is adjusted as desired.


click to play...

9. IR light cannot be seen by human eyes and only possible to be seen through the connected display monitor. Thus, make sure to adjust a night viewing angle in the dark and so the IR vision can be seen through the monitor. Objects exposed to the IR light that are too close to the camera will produce a white glow reflection, so pay attention to put objects at least 10ft away from the camera.


10. When the monitor location is out of viewable range from the camera, one more persons be needed to assist on correcting the camera-viewing angle, tilt, or pan adjustment while the other person is adjusting the actual camera angle at the camera location.


click to enlarge...click to enlarge...

11. Replace the dome cover in proper position not blocking the lens eye by the solid portion of the dome cover and screw back all Allen screws firmly with the enclosed Allen wrench.


click to enlarge...

12. At last, make sure to wrap around all cable connections securely with the electrical tape when wirings going through outdoor and intended to leave outdoor for long time.


 PAGE TOP

Home | About Us | Contact Us | Tech-Support | Product | Directory